08-31-2013 02:18 AM - edited 03-16-2019 07:08 PM
Hi All,
We are trying to register two sip trunks with two different providers. We managed to get them registered, but with the configuration in the cisco document, both credentials are sending to both providers, which results in a provider blocking our IP due to multiple wrong logins.
CIN-2921-1#sh sip register st
--------------------- Registrar-Index 1 ---------------------
Line peer expires(sec) registered P-Associ-URI
================================ ========== ============ ========== ============
SIPProvier1 -1 0 no
SIPProvier2 -1 0 no
--------------------- Registrar-Index 2 ---------------------
Line peer expires(sec) registered P-Associ-URI
================================ ========== ============ ========== ============
SIPProvier1 -1 38 no
SIPProvier2 -1 18 yes
Is there a way I can specify which credential should be used for which sip trunk?
Thanks
Solved! Go to Solution.
08-31-2013 11:40 AM
Please look at:
The Support for Multiple Registrars on SIP trunks feature has the following restrictions:
•Old and new forms of the registrar command are mutually exclusive: the registrar can be configured in either primary/secondary mode or multiple registrar mode—not both.
•Dynamic Host Configuration Protocol (DHCP) support is not available with multiple registrars (available for primary/secondary mode only).
•Only one authentication configuration per username can be configured at any one time.
•A maximum of six registrars can be configured at any given time.
•A maximum of 12 different realms can be configured for each endpoint.
•You cannot restrict the registration of specific endpoints with specific registrars—once a new registrar is configured, all endpoints will begin registering to the new registrar.
•You cannot remove multiple configurations of credentials simultaneously—only one credential can be removed at a time.
HTH
--
Jorge Armijo
Please remember to rate helpful responses and identify helpful or correct answers.
08-31-2013 08:43 AM
Hi,
Can you please share the running configuration from the Cube..
Regards
Jagpreet
08-31-2013 09:08 AM
This has been asked here several times, did you try searching for similar issue?
Chris
08-31-2013 11:14 AM
excuse me for my bad searching skills. So is the answer a NO?
08-31-2013 11:40 AM
Please look at:
The Support for Multiple Registrars on SIP trunks feature has the following restrictions:
•Old and new forms of the registrar command are mutually exclusive: the registrar can be configured in either primary/secondary mode or multiple registrar mode—not both.
•Dynamic Host Configuration Protocol (DHCP) support is not available with multiple registrars (available for primary/secondary mode only).
•Only one authentication configuration per username can be configured at any one time.
•A maximum of six registrars can be configured at any given time.
•A maximum of 12 different realms can be configured for each endpoint.
•You cannot restrict the registration of specific endpoints with specific registrars—once a new registrar is configured, all endpoints will begin registering to the new registrar.
•You cannot remove multiple configurations of credentials simultaneously—only one credential can be removed at a time.
HTH
--
Jorge Armijo
Please remember to rate helpful responses and identify helpful or correct answers.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide