Can we use csim start <Mobile nukmber> command to check the voice call connection for PRI lines.Because for few service provider the calls are not established.when checked with debug we have found an error "**ERROR**: isdnAsn1Component: ERROR" & "**ERROR**: process_facility_supp_services: Decode of facility IE operation failed"
I am not using any ip phones or communicator as of now.Just i am using csim start from router to my mobile number. Router has two pri lines from different service providers.when i dial with 1st SP the call is connecting perfectly but when i go for the second pri the call is disconnecting.I have done the same configuration for the both lines.also attached the failed call logs.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...