Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

VIP Super Bronze

CSS and Partition Problems

I have recently implemented a new VG in a remote office.

For users in that remote office to use this new VG, I have created new partitions and CSS and assign route-patters to the new partition and new VG.

The strange thing i am experiencing is that when I put two IP Phones into this new CSS and Partiton, they cant even call themselves.

Users in other CSS and partiton cant call phones in this new CSS and partition.

I am at loss.

I have added existing partiton to this new CSS and added the new partition to the existing CSS.

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
2 REPLIES
Silver

Re: CSS and Partition Problems

Is this a centralized model?

Are both of the remote IP phones registered with CCM?

Can you ping the IP phones from the CCM itself.

Ajaz

VIP Super Bronze

Re: CSS and Partition Problems

Thanks Ajaz,

I have resolved the poroblem.

The problem was with the priority on the new partition I created. Using route plan report, I found out that the old partition was still in existence and calls were been routed to it even though I was not logged into that profile.

So what I did was to make the new partition a higher priority and that worked fine

Thanks

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
104
Views
0
Helpful
2
Replies
CreatePlease to create content