I have about 100 phones with the DN in PT_ALL and a CSS of CSS_PRI and thy can all call each other fine.
one of the phones in PT_ALL can not be dialled by other phones with the CSS of CSS_PRI. Just get NU
it only works if I create a Translation pattern for the number in PT_private and forward it out with a css they does not include the PT_private partition
so for some reason when dialling this one extension the css must see the number in the PT_private partition. I have searched cm and can't find any instance of it in that partition could it be stuck somewhere?
Is it the same DN? for example 1000 in PT_private and 1000 in PT_ALL ?
If that is your case then is working as designed you will only reach 1000 in PT_Private and never 1000 in PT_ALL
If that is not our case, then perhaps you could elaborte, include extensions, partitions, css, etc. as much details as possible, it would be better if you could also include a CCM detailed trace of the call.
Have you confirmed through the route-plan report that there is no orphan DN500 other than that in PT_ALL?
You should only see one instance, not including the translation if present. There is a DN500 that is not associated with the phone, and is not the translation then you should delete, it should not be active anyway.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.