Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started.

New Member

CSS/Partition for Gateway/Phone

CSS/Parition question. Inbound calling. MGCP. If I have a site where the CSS assigned to the gateway is called CSS_PSTN. A phone assigned to the "internal partition" CSS_COS5 (international calling), however the internal partition is not assigned to the CSS_PSTN. Incoming calls work fine, Can someone tell me how this is possible based on the current setup? I would think the gateway would need to have all partitions that are assigned to end points within its CSS. Thoughts?

  • IP Telephony
1 REPLY

Re: CSS/Partition for Gateway/Phone

It's possible that you have a translation pattern that the CSS PSTN can reach. Then, that translation pattern has a CSS that can reach the phones.

-nick

130
Views
0
Helpful
1
Replies