I have various CTI Route Points configured for a Paging System. I configured the maximum number of calls on the CTI route points to 1 and the busy trigger to 1 in order to restrict only one user to be able to send a live broadcast at a time. Everything is working as intended except when a user accidentaly left the phone idle (the user never hang-up), the route point will be busy as configured but my question is:
If there is a configurable timer or setting in order to cancel that call from the cti route point so it can be idle again and other users be able to send live broadcast page?
Thanks for the reply. Ok. It is happening quite a few times, it could be something else than user leaving phone not hang-up? Can the CTI Route Point be busy because of some other condition. Thanks again!
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.