Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

CUBE router stops processing calls

I have a 2901 router configured to act as a Unified Boarder Element Controller (CUBE)

I am working with a telco to test SIP trunking.

Problem is that after a fresh reboot of the Router the inbound and outbound SIP calls work correctly.  After a "while" (not sure how much time it takes) the router stops processing calls.  Debugs show the the calls are not trigging dial peer debug outputs so its failing.

If I reboot the router calls will work again, proving that the Telco is not a fault.

Is this a know issue and I missed a timer or something somewhere ?

Config attached with IP's and passwords cleaned out.

1 REPLY
Green

CUBE router stops processing calls

Hi,

I am not sure if it could be your dial peers are clashing an running away with CPU trying process these.

They are very similar

!
dial-peer voice 100 voip
description ***Back & Forth From CUCM***
destination-pattern ..........
!

!
!
dial-peer voice 200 voip
description ***Back & Forth From SIP Provider***
destination-pattern .T
!

For the dial peer to the CUCM can you at leat pick a match with the 1st digit or even more would be better.

Do all your CUCM DNs start with E.G. "5"

Change the peer to be

!
dial-peer voice 100 voip
description ***Back & Forth From CUCM***
destination-pattern 5.........
!

Regards

Alex

Regards, Alex. Please rate useful posts.
193
Views
0
Helpful
1
Replies
CreatePlease to create content