Sure but it depends how the CUBE responds to CUCM during the failure. For example, if you're using Options Ping and CUBE is hard-down, CUCM will see the SIP trunk as down and skip it automatically. If CUBE responds, the SIP response code will decide how CUCM responds. For example, a 500 series error would likely continue searching down the hunt list/line group. If you get a 404 not found, it will depend what the Stop Routing on Unallocated Number Flag service parameter is (True/False). Similarly, a 488 busy would depend on the Stop Routing on User Busy Flag service parameter.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...