Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CUBE SIP to h323

I'm running a Microsoft OCS R2 connected over SIP to a Cisco2821 running IOS 12.4.24T1 and a CCM running 4.0 connected to the same Cisco2821 over h323. Calls made from a Cisco Phone to OCS works fine, but it's not possible to establish a call from OCS to a Cisco Phone. The Cisco Phone is ringing, but when I pick up the phone, there is no voice and after about 7 seconds, the call is disconnected.

Any ideas?

Find attached the config of the Cisco2821 and the output of a debug ccsip messages.

1 REPLY

Re: CUBE SIP to h323

The call is disconnecting with cause=47, which is no resources. This is usually because you don't have a transcoder available, or you need an MTP and one isn't available, or the codec requested isn't a capability of the MTP/transcoder.

My best guess for this case is that you need a transcoder because of region configurations.

-nick

244
Views
0
Helpful
1
Replies