I am using CUBE with unity connection. somehow unity connection is not making any call to CUBE. for example when I call main number which is forwarded to mani call handler in CUX, it is playing main greeting, then I dial the extension during opening greeting, the phone doesn't ring and it goes directly to voicemail. Also when I leave a message, MWI doesn't turn on. so somehow CUX is not making call to CUBE. as far as partition and CSS, I am pretty sure they are configured correctly. where else should I check out? If you show me the troubleshooting steps, I'd be very appreciated.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...