Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CUBE with transoding, dtmf issue

Hi, gurus!

Need your help again..

Cisco 2811 recieves call from VOIP provider via h323, g729r8, fast start, dtmf-relay type is h245-alphanumeric.

Outgoing call must have the same parameters.

This Cisco executes an TCL/VXML IVR, after which the incoming call is connected to operator, which, in some cases, is a cellular phone, so that setup is made again from this Provider (looks like ipsec-on-stick).

When call setup is done, operator has oportunity to transfer call to a more qualified specialist pressing "0". But cisco does not recieve dtmf.

Here is my config:

voice service voip

allow-connections h323 to h323

allow-connections h323 to sip

allow-connections sip to h323

allow-connections sip to sip

redirect ip2ip

h323

no call service stop

call preserve

dspfarm profile 1 transcode

codec g711ulaw

codec g711alaw

codec g729ar8

codec g729abr8

codec g729r8

maximum sessions 6

associate application SCCP

! incoming peer, translate 84959888053->9888053

dial-peer voice 1 voip

translation-profile incoming 1

destination-pattern 84959888053

session target ipv4:this Cisco IP

incoming called-number 84959888053

dtmf-relay h245-alphanumeric

no vad

! transcode and send to IVR script on g711

dial-peer voice 2 voip

service ivr

destination-pattern 9888053

session target ipv4:this Cisco IP

incoming called-number 9888053

dtmf-relay h245-alphanumeric

codec g711ulaw

no vad

! when operator is selected, we need to play him a info message (so once again we use translation and transcoder)

dial-peer voice 916739 voip

description -=Operator1=-

translation-profile incoming 9

destination-pattern 989167396844

session target ipv4:this cisco IP

incoming called-number 989161182155

dtmf-relay h245-alphanumeric

codec g711ulaw (we need to play msg!)

no vad

! after transoder and "9"-stripping send to operator(g729,alpha)

dial-peer voice 100 voip

destination-pattern 8..........

session target ipv4:X.X.X.X

dtmf-relay h245-alphanumeric

no vad

And operator cannot send DTMF.

UPD: i think that the problem is in call legs created in this call. SCCP call legs use strictly inband Dtmf type, and H323 use h245-alphanumeric dtmf-relay.

282
Views
0
Helpful
0
Replies