CUBE15.1.3, DTMF conversion between KPML and RFC2833
I have CUBE15.1.3 and configured dial-peer,
-to/from CUCM, "dtmf-relay sip-kpml rtp-nte"
-to/from ITSP, "dtmf-relay rtp-nte"
-CUCM SIP Trunk for CUBE=OOB and RFC2833
I have couple UC applications attached to CUCM8.5 which supporting KPML and RFC2833 depends on the application type, works okay the DTMF mechanism without MTP anchor which means no DTMF mismatch issue on CUCM.
My concern is, as per PDI help desk, Cisco developer confirmed that CUBE is not supporting the DTMF conversion between KPML and RFC2833, nor road-map. I tested the DTMF conversion feature with the above configuration of CUBE and CUCM in the LAB without any problem (no MTP anchor) but wonder why its not supporting model on CUBE.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...