Question regarding CUCM 10.5 LDAP integration: There are 2 CUCM 10.5 clusters that will be LDAP integrated to a single OU. How can it be set-up so that each CUCM will only sycnh its user base with corresponding members at their physical location and not entire OU user base? For example: 1 OU includes users at 4 sites. Two of these sites have CUCM 10.5 clusters and two have other systems. The intent is for each CUCM user base to include only users at their own locations and not the entire OU. Please advise.
"I believe that the greatest work of God has not been in the miraculous, nor in the spectacular, incomprehensible Creation, but rather I believe it was accomplished on the Cross where He Himself purchased the redemption of His Bride... the salvation of m
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...