Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CUCM - 3 mins to failover to 2nd CUCM server

I have two CUCM and want to know the failover delay mechanism.

-pri=CUCM#1 Active

-sec=CUCM#2 Standby

I applied ACL (block CUCM#1 from IP Phone) to test the failover to CUCM#2 and it took about 3 minutes to become CUCM#2 active.

Can I have an information why it took 3 minutes and any way to adjust?

Thanks in advance,

  • IP Telephony
1 REPLY
Bronze

Re: CUCM - 3 mins to failover to 2nd CUCM server

Hi, normally after three missed keeplives (30 sec by default), phone tries to establish a TCP connection with the secondary CUCM. However, I have some models (7905 and 7912) that take up to 2 minutes to register in my backup CUCM. You can modify the default value of keepalives in SYSTEM->SERVICE PARAMETERS->CCM SERVICE->STATION KEEPALIVE INTERNAL.

Hope this help.

David

127
Views
0
Helpful
1
Replies
This widget could not be displayed.