Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CUCM 4.2 integ with SIP Provider

I have terminated a SIP trunk on the voice gateway and configured it as CUBE. What configuration is required at Call manger 4.2 ? 

Regards

5 REPLIES
Cisco Employee

An h323 or SIP trunk to your

An h323 or SIP trunk to your CUBE, bear in mind that the SIP capabilities on 4.x were a lot more limited to those of current releases.
HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Can we use the existing H323

Can we use the existing H323 gateway in CUCM 4.2 and Create SIP dial peers with the ITSP.

If yes will it require any additional resoures.

Hall of Fame Super Silver

Sure, you will need to allow

Sure, you will need to allow sip to h323 connections under voip service.

 

Chris

New Member

I've created a route pattern

I've created a route pattern in CUCM 4.2 with wildcard 7!. This is pointing to a route list with H323 gateway. 

On the gateway i've created a dial peer :

dial-peer voice 40 voip

description **Outgoing Call to SIP Trunk

destination-pattern 7.T

session protocol sipv2

session target ipv4: 1.1.1.1

dtmf-relay rtp-nte sip-notify h245-alphanumeric

codec g711ulaw

no vad

----------- Is it enough to match the sip voip dial peer on gateway.

Cisco Employee

Yes, assuming that´s what

Yes, assuming that´s what your telco is expecting to receive.

Try placing a call, if it doesn´t work, enable debugs to look at the failure cause.

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
62
Views
12
Helpful
5
Replies