Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Anonymous
N/A

CUCM 5.1.3 and 7937 firmware

Hello

We recently acquired a 7937G conference station.   I uploaded the firmware to both cm nodes and restarted tftp services.  I plugged in the phone to our 3560 switch, the phone booted and updated software, but now is hanging with two alternating messages on the screen:  File Not Found and Configuring CM List.  On the phone settings for dhcp, cm servers, and tftp server are correct.

When I look at the cm admin webpage under Device Defaults, I see no listing for this model, nor any listing for it under Firmware Load Information.  Are there some further steps I need to take to get this phone to register?  Thank you!

2 REPLIES
Cisco Employee

Re: CUCM 5.1.3 and 7937 firmware

What you did is just upload a FW, and that's it. Uploading a FW DOES NOT ADD SUPPORT for a phone.

You need to install the latest devpack, which does add support for new phone models.

You'll need to restart the server after the install.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
Anonymous
N/A

Re: CUCM 5.1.3 and 7937 firmware

Hello

Thank for your very helpful response!

1036
Views
0
Helpful
2
Replies