Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

CUCM 5.1 3 selecting audio port range IP comminicator

We are implementing IP Communicator for agents over the wan and wish to restrict the RTP audio. Below is a Cisco link that informs it can be done in CallManager as well as the communicator. However, I cannot find this option in the CUCM, Can anyone help

http://www.cisco.com/en/US/docs/voice_ip_comm/cipc/2_0/english/administration/guide/CADcfg.html#wpxref74880

Thanks

Simon

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: CUCM 5.1 3 selecting audio port range IP comminicator

Hi Simon,

When you configure IP Communicator in CUCM have a look at the Phone Configuration page, down towards the bottom. You will see;

Product Specific Configuration

and then these two options;

RTP Port Range Start

RTP Port Range End

Hope this helps!

Rob

4 REPLIES
Hall of Fame Super Red

Re: CUCM 5.1 3 selecting audio port range IP comminicator

Hi Simon,

When you configure IP Communicator in CUCM have a look at the Phone Configuration page, down towards the bottom. You will see;

Product Specific Configuration

and then these two options;

RTP Port Range Start

RTP Port Range End

Hope this helps!

Rob

Community Member

Re: CUCM 5.1 3 selecting audio port range IP comminicator

Thanks for this Rob

All the best

Simon

Hall of Fame Super Red

Re: CUCM 5.1 3 selecting audio port range IP comminicator

Hi Simon,

You are most welcome my friend :)

Cheers!

Rob

Community Member

Re: CUCM 5.1 3 selecting audio port range IP comminicator

Hi,

Is there any way of reducing the RTP port range globally on the CM, as opposed to just on the softphone phone configuration.

So that one could force a standard phone like a 7940 to only use a specific port range.

Thanks

345
Views
0
Helpful
4
Replies
CreatePlease to create content