I have a system whereby the S/W was only installed on one "half" of the cucm. I need to have it on both so I can switch versions. How do I resolve this?Do I switch versions on the the non-working half and then install the sw/a again ? - many thanks
Switch version is not designed to work as a backup. Switch version is revert to a previous version. So, if you would like to have this option available, you should download the latest SR/ES for the version you have an install that on the box. That would give you the option of switch version to the current version that you have.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...