Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

CUCM 6.0 LDAP and AD 2003

Hi friends,

I configured LDAP System (with AD 2003), LDAP Directory and LDAP Authentication.

I can see that end users defined in corporate directory gets synchronized into CM database. After synch, for example I can login to IPCC Admin Page, Extension Mobility, but I can't login to CM User Options (when I click login button, appears again the login prompt page).

For LDAP Attribute is used sAMAccountName.

For LDAP DN is used the Administrator account. LDAP User Search Base is dc=mydomain, dc=com, port 389, no SSL.

For LDAP Auth, LDAP Auth for End Users is checked. Same LDAP DN and User Search Base as above, port 389, no SSL.

What might be causing CM User Option login be unsuccessful?

Many thanks!

  • IP Telephony
1 ACCEPTED SOLUTION

Accepted Solutions

Re: CUCM 6.0 LDAP and AD 2003

Hi,

In the End user configuration page you should add your user as a member of the Standard CCM End Users group.

You can also "bulk" add users through the User Group Configuration page.

Best regards,

Stoyan Stoitsev

2 REPLIES

Re: CUCM 6.0 LDAP and AD 2003

Hi,

In the End user configuration page you should add your user as a member of the Standard CCM End Users group.

You can also "bulk" add users through the User Group Configuration page.

Best regards,

Stoyan Stoitsev

Re: CUCM 6.0 LDAP and AD 2003

Stoyan,

Oops!. Many thanks for remember the big detail!. I never checked if the users where added to CM End User Group :)

5 pts!

Regards,

- Adrián.

176
Views
0
Helpful
2
Replies
This widget could not be displayed.