Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

CUCM 6.1.2 - 2821GW - NM-HDV2-2T1 with MGCP

I am trying to add a 2821 via MGCP to CUCM with the HDV2 card, but I do not see the typical "onboard card" selection in the MGCP configuration. Not sure what else to select under the 2821 config in CCM. I added a 3845 without any issues - has the "onboard" option for the HDV2 module. Has anyone else seen this issue? Thannks.

2 REPLIES
New Member

Re: CUCM 6.1.2 - 2821GW - NM-HDV2-2T1 with MGCP

Nevermind found what I was looking for.

Re: CUCM 6.1.2 - 2821GW - NM-HDV2-2T1 with MGCP

Did you press save?

It won't give you subunit options until you save the setting.

I just tried it on my lab 6.x server and there were no problems.

-nick

132
Views
0
Helpful
2
Replies
CreatePlease to create content