CUCM 6.1(3) Called party through translation pattern
I'm trying to get called party name information on a call through a translation pattern. Calling party comes through fine on the called phone. I have my calling line, calling name, connected line and connected name all set to "allowed" in the translation pattern Is there a parameter I need to change somewhere that I'm forgetting?
Re: CUCM 6.1(3) Called party through translation pattern
You pretty much have it correct:
Phone A DN 221000
Phone B DN 221001
Translation pattern 1001 translates to 221001
When phone A dials 1001, phone B rings. Phone B sees calling name of Phone A but Phone A only sees “1001” I need for Phone A to see the called party name of Phone B. I’m basically trying use digit expansion by allowing the user to dial a 4 digit number to reach a 6 digit DN
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...