Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Silver

CUCM 6.1 BLF set-up

I am struggling with setting up BLF

I have looked through the SRND and cannot find how to make this happen.

I have a 7961 with a 7914 attached.

I have configured it for 8 lines.

I went into one of the Lines for one device that I am monitoring and set the line to be on a presence group I created.

I then go to the device that I am using to monitor and set that device to the same presence group and also SUBSCRIBE to the CSS where all the lines are at.

What am I missing or what link can someone share?

Thanks,

Rick

1 ACCEPTED SOLUTION

Accepted Solutions
Red

Re: CUCM 6.1 BLF set-up

SUBSCRIBE CSS is very similar to regular CSS.

In order to reach (see) the destination, the CSS needs to contain the destination partition.

Does "BlockCSS_US_AllowLongDist" CSS contains "PT_GLOBAL_OnNet" partition?

Thanks!

Michael

4 REPLIES
Red

Re: CUCM 6.1 BLF set-up

First of all, avoid using any presence group, per the KISS rule.

Second, identify who's the watcher and who's the watchee.

On the watcher device, you need to configure SUBSCRIBE CSS. On the watchee, you don't.

Reset watcher and watchee devices.

HTH

Michael

http://htluo.blogspot.com/

Silver

Re: CUCM 6.1 BLF set-up

Can you explain the SUBSCRIBE CSS?

I read that in the SRND but it was not very clear to me.

What I did was choose the CSS that is the same CSS for the lines I want to monitor.

Please see screenshots for the example.

Rick

Red

Re: CUCM 6.1 BLF set-up

SUBSCRIBE CSS is very similar to regular CSS.

In order to reach (see) the destination, the CSS needs to contain the destination partition.

Does "BlockCSS_US_AllowLongDist" CSS contains "PT_GLOBAL_OnNet" partition?

Thanks!

Michael

Silver

Re: CUCM 6.1 BLF set-up

Too funny.

I had not seen this yet and this morning created a new CSS just for the BLF and added the PT_GLOBAL_OnNet partition.

I added this to the SUBSCRIBE CSS and it worked.

Thanks!

even though I found it you did post the correct answer so a rating is in order!

Thanks,

Rick

205
Views
10
Helpful
4
Replies