11-04-2008 12:23 AM - edited 03-15-2019 02:20 PM
Hi all,
I am using CUCM 6.1.2.1119-1 with a 2821 gateway in the UK. The problem is the following : remote people can hear me but I can't hear them.
I think it comes from my PVDM2-48 because I can't see any "edsp" when I do a "sh voice dsp". Any idea to make these "edsp" appear?
I attached some information.
Thanks,
Julien
Solved! Go to Solution.
11-04-2008 04:19 AM
add this commands:
mgcp bind control source-interface FastEthernet0/1
mgcp bind media source-interface FastEthernet0/1
change the interface as it's just an example, then make sure you have the right routing coming from that ip address to your ip phones
HTH
java
if this helps, please rate
11-04-2008 04:19 AM
add this commands:
mgcp bind control source-interface FastEthernet0/1
mgcp bind media source-interface FastEthernet0/1
change the interface as it's just an example, then make sure you have the right routing coming from that ip address to your ip phones
HTH
java
if this helps, please rate
11-04-2008 05:58 AM
java,
Thank you very much for your reply, the mgcp commands saved the problem. In fact, my router has several IP addresses and it was communicating with the wrong one with the phones.
Thanks again,
Julien
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: