In virtual machines - you must meet the hard drive and memory guidelines set forth by the product requirements. I have found that 2GB is required to run CUCM in VMWARE. Try increasing your memory allocation to 2048MB and see if the application is more stable. (Hope that helps)
Thanks for the quick response. I am running VMware workstation 5.5.5 build 56455 which i have been using for running loads of cisco vmware - ICM, CCM 4.2(3), IPIVR etc with no issues. I will however give your suggestion of greater memory allocation a go. I have 4GB so I will allocate 2GB to this machine. Thanks
Check the free disk space on your volumes from SSH. I think it is show diskusage or similar. I recently did a 7.0 VMware with a 40GB drive and the main partition was only allocated like 12GB and it filled it to 100%. I had alot of very strange issues similar to the one you mention.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...