I have a customer with CUCM 6 and when they dial into the MeetMe DN, they are receiving an error message that states - "Extension 99996 is not available. Enter the number that you would like to transfer to." If I enter the MeetMe DN there, I get put on permanent hold. How do I trouble shoot this and get it working?
One more thing - I get this recording no matter where I dial from - externally or internally - so I know it's a configuration issue on the system.
I think we're getting somewhere. In CUCM, there is a Hunt Pilot for the number (5170) that sends the call to the voicemail ports. In CUC, there is a Direct Routing Rule that sends the call to the greeting of the MeetMe Call Handler. For that call handler, after the greeting is played, the option that is selected is "Conversation - Caller System Transfer". I don't see any reference to any of the MeetMe DN's that are setup within CUCM.
Figured it out. The call was actually flowing correctly - someone had gone in and changed the greeting to the default system greeting and that just so happens to be "Extension 99996 is not available" on this companies system. I changed the greeting to the one that they recorded and everything is working just fine now.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...