CUCM 7.1(3) and *69, *67, *57, etc.

[rcoote5902_2]

I've been asked to look into whether or not certain phone features like last-call return (*69) etc. work through our phones.  I set up a route pattern for *69 and it works, although it takes a while to dial due to the fact that it's only 3 digits.  Is there a way to force it to dial rather than timing out and then dialing?

Also, are there any documents or recommendations or setting up these telco features with CUCM?

Thanks

Rob

[Jaime Valencia]

It's weird it waits the IDT, the only explanation would be that there are other DNs in your CUCM that also start with *.

You can certainly configure those DNs as route patterns and check the urgent priority to have them go immediately

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk