Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CUCM 7.1(3b)SU2 CLIP HiPath E1 MGCP QSIG

Hi,

we are trying to connect a CUCM (Ver. 7.1(3b)SU2) with MGCP over a E1 trunk to a Hipath 4000. We use for the QSIG ECMA with Globale Values.

Features like callback and call forward by reroute works fine, but we don't get the caller name on the Cisco Phone (6961 and 7975) from the HiPath Phones.

I read also this bug CSCtc68166 at this post https://supportforums.cisco.com/message/3049636.

Have I maybe this issue with the 7.1.(3b)SU2 version, or should I downgrad to 7.1(3a)SU1 aka (7.1.3.21900-4)?

We still let configured at the HiPath the ?Segment? 8?

Thanks for your suggestions in advance.

Best Regards,

Paul

2 REPLIES
New Member

Re: CUCM 7.1(3b)SU2 CLIP HiPath E1 MGCP QSIG

Maybe some additional information.

In the debug log on the voicegateway (debug isdn q931) I didn't see any caller name from the Cisco Phone (also not in facility ie), only the name of the called phone which is connected to the hipath.

I try tomorrow to post the debuglog.

New Member

Re: CUCM 7.1(3b)SU2 CLIP HiPath E1 MGCP QSIG

We solved this issue, by not using the standard local route group inside the router pattern, which is pointing to the HiPath.

294
Views
0
Helpful
2
Replies
CreatePlease to create content