Have a CUCM 7.1(5) box with 2921 H323 gateways and PRI's to the PSTN. I have set my external Phone number mask to the standard format AAABBBCCCC. When I tell the route pattern or route list to use the phones external mask I see the Calling party as AAABBAAABBBCCCC when it is leaving my gateway to the PSTN. I see the same thing on both gateways and all 4 PRI's. If I hard set the CallerDN on the gatways in CUCM I get AAABBAAABBBCCC when the call leaves the gateway to the PSTN. Not even sure where to start looking at this one.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...