I recently integrated an SRE 710 module on my 2921 router that is used as an CUE AA. I use 2 scripts and need 12 cocurrent calls on the CUE. I have 2 other CUEs on other routers but erlier cue versions that operate with the same 2 scripts and work fine.
This new one it seems that everything is ok, it registers properly with my cucm but does not answer calls.
I did some traces and I found that jtapi seems deactivated and does not accept my calls, on the call manager my CTI Route points are registered properly.
I imagine that maybe it is a license problem (incorrect license) ? Could be ?
I used the show call-agent command: cucm, hence it is correct. The problem is that in the show license staus application i see that the voicemail is disabled, for some reason i cannot enable it! Please advice.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.