Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CUCM 7.1 and Mitel 5224 integration

Hello,

is it possible to integrate a Mitel 5224 IP Phone with Cisco Callmanager 7.1 over SIP?

I tried as Third-Party SIP Device, without success.

Can anyone say yes or no???

Thanks...

Christian

2 REPLIES
Silver

Re: CUCM 7.1 and Mitel 5224 integration

This document is for Mitel 3300 and CUCM 6.x but it could work for your version as well. Please note you can also integrate the mitel with the gateway. The config is included.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/pbx/interop/notes/678773.pdf

Mitel-Cisco Gateway integration:

voice service voip

allow-connections sip to sip

redirect ip2ip

sip

bind control source-interface GigabitEthernet0/1

bind media source-interface GigabitEthernet0/1

options-ping 90

no update-callerid

!

interface GigabitEthernet0/1

ip address 10.10.X.X 255.255.255.0

no ip route-cache cef

no ip route-cache

duplex auto

speed auto

hold-queue 2048 in

hold-queue 2048 out

!

!

dial-peer voice 20 voip

description "Dial Peer From Mitel"

translation-profile incoming MITEL_CUCM

voice-class codec 1

session protocol sipv2

session transport tcp

incoming called-number +74...

dtmf-relay rtp-nte sip-notify

!

dial-peer voice 30 voip

description "Dial Peer To Mitel"

destination-pattern 65...

voice-class codec 1

session protocol sipv2

session target ipv4:10.10.X.X

session transport tcp

dtmf-relay rtp-nte sip-notify

Translation Profile is to strip the "+" away.

Good luck,

MK

Green

Re: CUCM 7.1 and Mitel 5224 integration

869
Views
0
Helpful
2
Replies
CreatePlease to create content