CUCM 7.1 interface with CA Spectrum Management Software through SNMP v2
I am configuring CUCM 7.1 to interface with CA Spectrum management software through SNMP v2, the administrator of the CA Spectrun Software is asking for the MIBs & OID. From where I can get the MIBs & OIDs and which MIBs & OIDs I should send to CA Spectrum Management software administrator to work it properly with CUCM 7.1.
Re: CUCM 7.1 interface with CA Spectrum Management Software thro
This request does not make sense. MIBs are only a definition file of what OIDs are available as well as what data they provide. I can see why an application developer may be interesting in seeing these; however, an administrator of a wallboard application for a contact center seems odd.
In any event, here is the documentation on SNMP for UCM:
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...