03-26-2009 12:39 PM - edited 03-15-2019 05:07 PM
We are integrating a CUCM 7 to a service provider SIP trunk for basically calling out but I can not find where to place the user/pass that the carrier ask for.
Do I have to use forcibly a Gateway? or is there a guide?
Solved! Go to Solution.
03-26-2009 01:10 PM
There is no entry for a username/pass configuration on the CUCM and will require the use of a IPtoIP gateway or CUBE as it's commonly known as.
You would be entering your credentials under the sip-au configuration mode on the gateway.
Matt
03-26-2009 01:48 PM
CUCM does not support registering numbers to a SIP provider.
You may want to look into CUBE for this feature.
-nick
03-26-2009 01:10 PM
There is no entry for a username/pass configuration on the CUCM and will require the use of a IPtoIP gateway or CUBE as it's commonly known as.
You would be entering your credentials under the sip-au configuration mode on the gateway.
Matt
03-26-2009 01:48 PM
CUCM does not support registering numbers to a SIP provider.
You may want to look into CUBE for this feature.
-nick
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: