Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CUCM 7 Service provider SIP

We are integrating a CUCM 7 to a service provider SIP trunk for basically calling out but I can not find where to place the user/pass that the carrier ask for.

Do I have to use forcibly a Gateway? or is there a guide?

2 ACCEPTED SOLUTIONS

Accepted Solutions

Re: CUCM 7 Service provider SIP

There is no entry for a username/pass configuration on the CUCM and will require the use of a IPtoIP gateway or CUBE as it's commonly known as.

http://www.cisco.com/en/US/products/sw/voicesw/ps5640/products_configuration_example09186a00808ead0f.shtml

You would be entering your credentials under the sip-au configuration mode on the gateway.

Matt

Re: CUCM 7 Service provider SIP

CUCM does not support registering numbers to a SIP provider.

You may want to look into CUBE for this feature.

-nick

2 REPLIES

Re: CUCM 7 Service provider SIP

There is no entry for a username/pass configuration on the CUCM and will require the use of a IPtoIP gateway or CUBE as it's commonly known as.

http://www.cisco.com/en/US/products/sw/voicesw/ps5640/products_configuration_example09186a00808ead0f.shtml

You would be entering your credentials under the sip-au configuration mode on the gateway.

Matt

Re: CUCM 7 Service provider SIP

CUCM does not support registering numbers to a SIP provider.

You may want to look into CUBE for this feature.

-nick

171
Views
0
Helpful
2
Replies