Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CUCM 8.5(1) and 8831 SIP Phone

I have a client running CUCM 8.5.1.11900-21. They have purchased some 8831 conference phones. In order to configure the phones do I need to install the Device Pack (cmterm-devicepack) or just the firmware (cmterm-8831-sip.9-3-3-5) for the 8831?

 

If I install the device pack; will it change the default firmware load for all other phones?

 

Thank you in advance for your assistance. 

2 ACCEPTED SOLUTIONS

Accepted Solutions
Cisco Employee

Hi Bill,Please check the

Hi Bill,

Please check the following post for the answers

https://supportforums.cisco.com/discussion/11833946/code-8831-conference-phone

Yes, installing a device pack does change the default loads for all IP phones.

HTH

Manish

It will change the default

It will change the default loads for all phones but you can take note of the old device defaults and set them back before you do the cluster reboot after installing the device pack.

2 REPLIES
Cisco Employee

Hi Bill,Please check the

Hi Bill,

Please check the following post for the answers

https://supportforums.cisco.com/discussion/11833946/code-8831-conference-phone

Yes, installing a device pack does change the default loads for all IP phones.

HTH

Manish

It will change the default

It will change the default loads for all phones but you can take note of the old device defaults and set them back before you do the cluster reboot after installing the device pack.

96
Views
0
Helpful
2
Replies