Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CUCM 8.5 and CME 7.0

Hi there,

This is my question, it might not make much sense, but I'm asking anyway..

I have 2801 running CME 7.0 it works well so far been running for about a month, with all inbound outbound calls work flawless, knock on wood ..

The router is also used as a WAN router which is connect directly to ISP's Internet and SIP carrier ..

I have added a Unity and CUCM 8.5 on a server connected on the same LAN, i configured a DP for the CUCM 8.5 on the router and was able to register Cisco IP Communicator and and successfully dial out, however I couldn't get inbound calls..

I did create a DP with the full DP as destination pattern, but the call didn't get to the CUCM 8.5, it simply failed.

Also i have a SIP trunk on the CUCM 8.5 to the CUBE and appropriate DP..

My question would be is it possible to run a CME 7.0 and CUCM 8.5 at the same time using the same router/CUBE ?

Thanks for reading and even better replying .

2 REPLIES
Hall of Fame Super Silver

CUCM 8.5 and CME 7.0

Sure.

Please post your configuration along with "debug ccsip messages", "debug voice dialpeer" and what number you dialed.

Chris

New Member

Re: CUCM 8.5 and CME 7.0

Hey Cris,

I have attached the logg file with the debugs..

Thje CM local ip is 172.22.100.200 and DP is 8, number called is three473124343

Thanks

364
Views
0
Helpful
2
Replies