CUCM 8.5 Local Syslog set to Error (3) default but RTMT showing Informational (6) and higher alarms
I have several CUCM systems all running ver. 8.5. The Local Syslog configuration in Unified Serviceability was left at the default value Error (Severity Level 3) yet for all systems the Local Syslog Viewer in RTMT is showing alarms as if the Local level was set to Informational (Level 6) ie. I am seeing all alarms from Informational (6) through Emergency (0)!
This is true for the Syslog messages in both the Local Syslog and the Alternate Syslog.
Also, even though I have not selected 'Exclude End Point Alarms' in Seviceability-->Alarm Configuration-->Service Group-->CM Services-->Service-->Cisco CallManager, I'm seeing that the phone-related endpoint alarms are already going into the Alternate Syslog!
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...