I am upgrading from CUCM 6.1.5 in a VM Workstation Lab environment in anticipation of receiving my new hardware. I am trying to download 8.6(2)SU1 from Cisco and it says it should be 4.4gb but I only get 437mb at the completion of the download.. Is this correct?
Am I supposed to upgrade to 8.6 then to this new release?
And before anyone says anything I know about bridging the upgrade to a different MCS for the upgrade but that is easily gotten around by going to 7.1 first. Which I have done successfully on the VM. I am just confused because when I downloaded 7.1 the size info was correct and the 8.6(2)SU1 has not been. I have tried 3 times.
You're correct, the ISO is now over 4GB in size. Apparently CCO is at the bar instead of serving up downloads tonight. You may want to try the Java download option to see if that helps. If not you could open a TAC case and ask that they post it to you through special file access which would use a different set of servers.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...