CUCM 8.6.2 - support IP Phone GXP2100 (Grandstream)
My Customer have the CUCM 8.6.2 and would like know if the IP phone model GXP2100 (SIP) is supported for this version. I search in the Cisco site and not found this information. Is there any documentation Cisco about this?
No, you should know by now that we don't test 3rd party phones, if it supports SIP, it might be configured as a SIP 3rd party endpoint. But you won't find anything besides the generic SIP 3rd party endpoint config on cisco.com, we won't provide instructions on how to configure the actual endpoint.
Few months back I have configured it as a third party SIP basic phone in CUCM 8.6 and it was registered successfully but unfortunately conference didn't work on it, so customer left the idea to use this before putting more efforts on troubleshooting.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...