CUCM 8.6(2a) New Subscribers show 0.0.0.0 ip address on phones
I have an issue that is crazy. After upgrading to fix other bugs to 8.6(2a) from 8.6(1a) the two newest subscribers cannot register phones directly and once the phone register to the pub or another sub, the newest sub show and IP address in the phones of 0.0.0.0. I have rebuilt the new sub, check replication, checked DNS, checked connectivity, checked services, check just about everything I can and still nothing. I have a TAC case open but I am curious if others out there have seen this????
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...