I had a working scheme: CUCM - h323 GW - IPtoIP - h323 GW SP
But resently something happened: now simultaneously I have only 3 active calls through my provider's GW. Fourth,
fifth and next calls drops by timeout.
I didn't change Locations in CUCM, by default - unlimited.
Then the call is unseccessful, RTMT shows ( 47 ) Resource unavailable, unspecified.
But I have free DSP resurses.
IOS version on my GW - 15.1(4)M2
It seems that while 3 calls are in progress, GWs can't understand each other over h245 about next call. They can't find adress and port for date transfer (RemoteMediaIPAddress=0.0.0.0 RemoteMediaPort=0). And at the same time CoderTypeRate=g729r8 pre-ietf, but I don't use this codec.
Providers GW IP - AAA.BBB.CCC.DDD
My GW IP - 10.10.10.72
My GW Loopback - 10.255.255.10
There is a calling number translation in IPtoIP settings. All calling numbers translates to 8YYYYYYYYYY
220.127.116.11 - CUCM Publisher
18.104.22.168 - CUCM Subscriber
Calling number - 8XXXXXXXXXX
There are logs of "lucky" and "unlucky" calls in attachments:
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4