Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

CUCM 8 on VMWare 4.1

     I had a CM7 running in VMWare 4.0, but I upgraded my POD to 4.1, and I got UC8 just today. It gives me an error complaining about base_scripts/hardware_check.sh Input Output errors. The errors happen almost immediately. I have set it up on Intel platform with 1 CPU, 2G of memory, 80G of disk. Any ideas about how to get past this? Thanks in advance.

1 REPLY
Community Member

Re: CUCM 8 on VMWare 4.1

When you make the installation , at the beginning

when ask about check the hardware , press No

and about the specification in VMware

1 Proc, 100G Hard disk SCSI, 2G Mem, Network Bridged

I hope this help you

If this is helpful, plz rate

228
Views
0
Helpful
1
Replies
CreatePlease to create content