i know that is better specify an IP address for all member of CUCM cluster. The procedure deals with going to CUCM servers, change the name to IP and, finally, change the URL's in "enterprise parameters" to allow phones use IP too. My question is which configuration steps are better between this 2:
A. Configure all cluster members by name and, after the last subscriber is added, change the names to IP of all members (and change "enterprise parameters" URL's)
B. Install the Publisher, change his name to IP, add the following Subscribers using IP directly.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...