I'm getting ready to use LDAP synchronization with CUCM 7.1.3.
I have about 2000 users. When I tell it to sync should I be doing this at a time of low utilization or can I do it in the middle of the day without disrupting things?
Also it does not appear there is an easy way to test. If I turn on synchronization any userid's that have a matching entry in AD will be overwritten by the information coming from AD - even if I turn off synchronization before the nightly garbage collection process runs?
The minute you enable the sync process it will start pulling the info, for that amount of users it shouldn't take long.
Also, even if you disable it the users won't be deleted as there are some time consideration about when users will be deleted by the garbage mechanism, if you're interested the whole explanation is under LDAP chapter from SRND.
As mentioned, there is no way to test this, other than enabling it.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...