Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CUCM and VCS Integration

Hi everyone,

I want to integrate CUCM v.7 with VCS and VCS-Express. The question is can I dial a URI from Cisco IP phones like 8961 or 9971? And from Old version CUCM 7.1 or I have to upgrade to CUCM v9 or 10

 

 

 

  • IP Telephony
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Nope, phone number only.Chris

Nope, phone number only.

Chris

4 REPLIES
Hall of Fame Super Silver

URI dialing was added in CUCM

URI dialing was added in CUCM 9.0, so you need to upgrade if you desire to dial via URI.

Chris

New Member

Thank you what if I need to

Thank you

 

what if I need to dial by IP?

Can I do it in CUCM 7?

Hall of Fame Super Silver

Nope, phone number only.Chris

Nope, phone number only.

Chris

For dialling a URI, the only

For dialling a URI, the only way to get anywhere close, is to do some digit translation magic on the VCS. But this means pre-configuring every URI you intend to dial on the VCS and assigning it a DN.

 

For IP Addresses, I believe there's a way to do digit translation on the VCS to turn a DN into an IP address.

 

GTG

Please rate all helpful posts.
62
Views
5
Helpful
4
Replies