I have just built a cucm7 and imported a database from a DMA from ccm4.1. I have renamed the annunciators as ANN_1 and ANN_2 where ANN_1 picks up its IP address of the Publisher server and ANN_2 picks up its IP address of the Subscriber server. However,the annunciator related to the Publisher server wont register. It just sit there with its status unknown. I have tried restarting the Cisco IP Voice Media Streaming Application service and have tried rebooting the server. The annunciator on the Subscriber is up and running fine.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.