I'm attempting to setup email alerts for successful/failed backups in CUCM. I currently have the mailserver configured using RTMT and have alerts enable for CiscoDRFFailure. I have 2 questions however...
1. - Is there a way to configure the alerts for CiscoDRFFailue to also report the successes. If not, how can I go about doing that? I see that there is an alarm for DRFBackUpCompleted, but i cant seem to find it for a custom alert (nor have I set up any custom alerts as of yet)
2. - How can I test mailflow for the alerts? I pretty sure I have everything configured correctly, but just want to make sure that if the alert is triggered, that I will in fact receive an email for it. I dont see a test connection or test mailflow option.
Any suggestions would be greatly appreciated! Thanks in advance all!
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...