Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CUCM-BE 7.1.3 Cannot export phone Specific Details

I recently installed CUCM-BE 7.1.3 and have found that after adding phones that I cannot export phones with Specific details.  I can look at the Job request listing as "complete, but the Job Results information is blank below the header.

If I export All Details I can pull down the file, but is basically useless due to there are to many fields for Excel to load properly.

I have exported the same specific details with CUCM 6.1.2 and worked fine.  The problem has occured with 7.1.3-20000 and 7.1.3-31900, so far.

Anyone else experience this issue?  If so are you using a customer phone information or one of the generics?

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: CUCM-BE 7.1.3 Cannot export phone Specific Details

Hi John,

It sounds like you may be hitting this bug;

CSCtb95233 Bug Details Bug #29 of 96 | < Previous | Next >

Bulk Administration Phone Export
Symptom:
When attempting to use Bulk Administration->Phones->Export Phones->Specific Details after selecting your phones to export if you choose a custom custom made file format and not one of the Cisco defaults and run the job, in the job status screen it will immediately say "complete" but the job never ran and no file is exported.

Conditions:
Exporting phones with specific details via BAT using a custom file format.
It is caused by the "Owner User ID" column in the file format chosen.


Workaround:
use a file format without "Owner User ID" column in the file format chosen
Status
Fixed             

Severity        
3 - moderate


Last Modified
In Last month        

Product
Cisco Unified Communications Manager (CallManager)         

Technology


1st Found-In
7.1(2.39111.4)       
           
Fixed-In
7.1(4.98000.44)
7.1(3.21008.1)

Hope this helps!

Rob

2 REPLIES
Hall of Fame Super Red

Re: CUCM-BE 7.1.3 Cannot export phone Specific Details

Hi John,

It sounds like you may be hitting this bug;

CSCtb95233 Bug Details Bug #29 of 96 | < Previous | Next >

Bulk Administration Phone Export
Symptom:
When attempting to use Bulk Administration->Phones->Export Phones->Specific Details after selecting your phones to export if you choose a custom custom made file format and not one of the Cisco defaults and run the job, in the job status screen it will immediately say "complete" but the job never ran and no file is exported.

Conditions:
Exporting phones with specific details via BAT using a custom file format.
It is caused by the "Owner User ID" column in the file format chosen.


Workaround:
use a file format without "Owner User ID" column in the file format chosen
Status
Fixed             

Severity        
3 - moderate


Last Modified
In Last month        

Product
Cisco Unified Communications Manager (CallManager)         

Technology


1st Found-In
7.1(2.39111.4)       
           
Fixed-In
7.1(4.98000.44)
7.1(3.21008.1)

Hope this helps!

Rob

New Member

Re: CUCM-BE 7.1.3 Cannot export phone Specific Details

That worked perfectly!!!  The TAC engineer could not figure that one out.

Thank you very much.

256
Views
0
Helpful
2
Replies
CreatePlease to create content