Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

CUCM CDR Reports don't show called number before being translated

Hi there,

by any chance you know of any way to bypass this limitation from CUCM? - I have been looking everywhere with no luck. when we download the CDR reports from CUCM it comes with all the translated numbers instead of the Original Called Number.

Please help!!!

1 ACCEPTED SOLUTION

Accepted Solutions

CUCM CDR Reports don't show called number before being translate

Hi Andres

Based on the below document

http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/service/8_5_1/cdrdef/cdradmin/cdrfdes.html

originalCalledPartyNumber

Text String

This field specifies the number to which the original call was presented, prior to any call forwarding. If translation rules are configured, this number reflects the called number after the translations have been applied.

This field represents a numeric string of up to 48 characters that can be either digits or a SIP URL.

Default - Empty string " ". If destination cannot be reached, this field stays empty.

Thanks

Please rate all useful information

2 REPLIES

CUCM CDR Reports don't show called number before being translate

Hi Andres

Based on the below document

http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/service/8_5_1/cdrdef/cdradmin/cdrfdes.html

originalCalledPartyNumber

Text String

This field specifies the number to which the original call was presented, prior to any call forwarding. If translation rules are configured, this number reflects the called number after the translations have been applied.

This field represents a numeric string of up to 48 characters that can be either digits or a SIP URL.

Default - Empty string " ". If destination cannot be reached, this field stays empty.

Thanks

Please rate all useful information

This is a very old question,

This is a very old question, but time and experience have shown me that there are many wasy to skin a cat.

This can be accomplished in many ways and even without applying translation patterns in CUCM and then define all DIDs into the CUBE gateway which was my case. This client has 500+ DIDs but this can be accomplished in new IOS releases where a new Dial-Peer that looks at a list of DIDs in flash can be used, very little maintenance and overhead.

Create a file with e164 numbers and call it e164-pattern-map.cfg

the file will contain the following:

3051111111
3051111112
9541111212
8912221212

Save the file in Flash, and the following is how you call it:

voice class e164-pattern-map 100
 url flash:e164-pattern-map.cfg

dial-peer voice 100 voip
 destination e164-pattern-map 100
 session target ipv4:x.x.x.x
216
Views
0
Helpful
2
Replies