Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

CUCM configuration file

Hi All,

is it possible to configure CUBE, backup from configuration, then restore to CUCM? both are using the same version.

any suggestion would be appreciated.

Alex

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: CUCM configuration file

Can you elaborate on exactly what you're looking for??

If you mean backup all in 1 click that's not supported, you need to backup CUBE and CUCM separately

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
3 REPLIES
Cisco Employee

Re: CUCM configuration file

Can you elaborate on exactly what you're looking for??

If you mean backup all in 1 click that's not supported, you need to backup CUBE and CUCM separately

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
Community Member

Re: CUCM configuration file

thanks for the reply.

we have upcoming project with CUCM 7.0, but we are really tight in timeframe. I have CUBE in the lab. I want to configure everything such as dialplan, users, BAT, .... in CUBE, then when we receive CUCM, restore the configuration to CUCM. in this case, we can catch up with project.

thanks for the suggestion.

Alex

Cisco Employee

Re: CUCM configuration file

NO, BAT and CUBE just cannot be in the same sentence as they don't even belong to the same technology.

You save your sh run in CUBE and use DRS in CUCM.

You can do all the CUBE config, but that's it. CUBE CONFIG.

CUCM config STAYS in CUCM.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
410
Views
0
Helpful
3
Replies
CreatePlease to create content