Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

CUCM equivalent to CME silent button commandHi

Hi, I have a customer moving from CME to CUCM 8.5.

In the CME config they use the button1s1 command which enables the silent ring feature for the line. Lines on other buttons will still ring.

Is there any way to mimic this on CUCM?

CUCM DND turns off the ringer for all lines on the device.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: CUCM equivalent to CME silent button commandHi

Hi James,

Well you can the Ring Setting - Phone Idle & Phone Active to Flash Only

on Line 1 under the DN config page itself. This would have no effect on the other

lines on the phone

Cheers!

Rob

3 REPLIES
Hall of Fame Super Red

Re: CUCM equivalent to CME silent button commandHi

Hi James,

Well you can the Ring Setting - Phone Idle & Phone Active to Flash Only

on Line 1 under the DN config page itself. This would have no effect on the other

lines on the phone

Cheers!

Rob

CUCM equivalent to CME silent button commandHi

Rob you are a superstar

Hall of Fame Super Red

CUCM equivalent to CME silent button commandHi

Hey James,

Thanks for your kind words buddy, but I've put up so many terrible answers here

that I should have probably been banned from CSC at this point Hahahaha!

Here's one from yesterday...yikes!! What was I thinking??

https://supportforums.cisco.com/thread/2117495?tstart=30

Glad to be of some small help here.

Cheers!

Rob

360
Views
0
Helpful
3
Replies
CreatePlease to create content